ConverterHub

Ohm's Law Power Calculator

Find power and resistance from voltage and current.

Result

30.00 W
4.80 Ω

How it is calculated

This tool takes two known values, voltage V in volts and current I in amperes, and returns P = V × I in watts and R = V ÷ I in ohms. Those are the power and Ohm's law relations for a DC circuit or a purely resistive load. The current must not be zero, since the resistance would be undefined, and no result is shown for it. Negative values are not rejected, so a negative current gives negative power and resistance, which is not physically meaningful for a resistor. Only voltage and current are inputs here; it does not solve from other pairs, such as power and resistance. Results are rounded to two decimals.

Worked example

A 12 V device draws 2.5 A. Power: 12 × 2.5 = 30.00 W. Resistance: 12 ÷ 2.5 = 4.80 Ω. Check using the other power formula: P = I² × R = 2.5² × 4.8 = 6.25 × 4.8 = 30 W, the same answer. A power supply feeding this device should be rated well above 30 W, because supplies are not meant to run at their limit.

Try this example →

Common mistakes

  • Entering current in milliamps. A 500 mA load must be typed as 0.5, otherwise the power is a thousand times too high.
  • Applying the DC formula to an AC load without the power factor. For motors and transformers, V × I is apparent power, not real power.
  • Treating the resistance as a property of a lamp or LED at all voltages. The value shown applies at that operating point; it changes with temperature.
  • Entering the supply voltage when the voltage across the component is smaller, for example after a series resistor.
  • Confusing watts with watt-hours. Power is the rate; energy is power multiplied by time.

About this calculator

This calculator combines Ohm's law (V = I·R) with the power formula (P = V·I) to find electrical power, and can also solve for resistance, current, or voltage when any two of the four quantities are known — deriving relationships like P = I²R and P = V²/R along the way. These equations describe how voltage, current, resistance, and power relate in any DC circuit, from a single resistor to a full electrical load.

Electrical and electronics students working through circuit-analysis homework, hobbyists building Arduino or Raspberry Pi projects who need to size a resistor or check a component's power rating, and electricians verifying that a device won't exceed a circuit's wattage capacity use this. Enter any two known values — voltage, current, resistance, or power — to solve for the rest.

Was this helpful?

You can pick up to 3 reactions.

Comments (0)

  • Be the first to comment.

Popular calculators

Loan Calculator

Monthly payment, total interest and full amortization schedule.

Percentage Calculator

Percent change, percent of, and ratio calculations.

Discount Calculator

Calculate final price, savings, and discount amount.

BMI Calculator

Body mass index from height and weight (metric or imperial).

Age Calculator

Compute your exact age in years, months and days from a birth date.

Compound Interest Calculator

Calculate the final amount and interest earned with compounding.

All Calculators