Two-Pulley Belt Length Calculator
Enter the center distance and both pulley diameters to size your belt.
Result
How it is calculated
The tool uses the common approximation for an open belt: L = 2C + π(D + d)/2 + (D − d)² / (4C). C is the centre distance between the two shafts, D the large pulley diameter and d the small pulley diameter, all in millimetres (the tool labels results in mm, so convert inches first). The first term is the two straight runs, the second is the belt wrapped around the average pulley circumference, and the third adds the extra length caused by the size difference. The length is shown to one decimal in mm and also in inches (mm ÷ 25.4). All three values must be above zero. The tool does not check that the pulleys fit, and swapping D and d gives the same length, because the difference is squared. It is a pitch-length estimate: it ignores belt thickness and standard belt sizes.
Worked example
Centre distance C = 500 mm, large pulley D = 200 mm, small pulley d = 100 mm. Straight runs: 2 × 500 = 1000 mm. Wrap: π × (200 + 100) / 2 = π × 150 = 471.2 mm. Size correction: (200 − 100)² / (4 × 500) = 10000 / 2000 = 5.0 mm. Total 1,476.2 mm, which is 58.12 in. In practice you would then pick the nearest standard belt length and adjust the centre distance slightly to suit it.
Common mistakes
- Entering the pulley radius instead of the diameter. The formula needs diameters; radii give a belt far too short.
- Entering inches or centimetres while the result is labelled in millimetres. Convert everything to mm first.
- Using the outside diameter of a V-belt pulley instead of the pitch diameter, where the belt actually rides.
- Treating the answer as a catalogue size. Belts come in standard lengths, so round to the nearest available one and allow for adjusting the shaft spacing for tension.
- Using this for crossed belts or more than two pulleys. The formula is for an open belt over exactly two pulleys.
About this calculator
Sizing a flat or V-belt for a two-pulley drive means finding the belt length that lets it wrap both pulleys and run taut across the center distance between them, without being so tight it strains the bearings or so loose it slips. The standard formula is L = 2C + π(D + d)/2 + (D − d)²/(4C), where C is the center distance, D is the large pulley diameter, and d is the small pulley diameter — the π(D+d)/2 term accounts for the belt wrapped around both pulleys, and the last term corrects for the extra length needed when the pulleys are different sizes.
Mechanical designers and machinists use this formula (or its close variants) when specifying a belt for conveyors, compressors, motors, and other belt-driven machinery, since ordering the wrong belt length means either a drive that can’t be tensioned properly or one that won’t fit the pulleys at all. This calculator takes your center distance and both pulley diameters to compute the required belt length directly.
Was this helpful?
You can pick up to 3 reactions.
Popular calculators
Loan Calculator
Monthly payment, total interest and full amortization schedule.
Percentage Calculator
Percent change, percent of, and ratio calculations.
Discount Calculator
Calculate final price, savings, and discount amount.
BMI Calculator
Body mass index from height and weight (metric or imperial).
Age Calculator
Compute your exact age in years, months and days from a birth date.
Compound Interest Calculator
Calculate the final amount and interest earned with compounding.
All Calculators
No calculators found
Comments (0)